The installation includes automation support that can increase productivity by reducing the time required to collect and validate data. The relationship between the individual measurements and the amplification of noise and vibration processes phase and SVT amplification and phase VI measures amplification and phase delay between the stimulus channel and the response channel at the test frequency. Fig. 12-1. Waterfall display for frequency analysis initial display Use initialize WE WASASE Wasserfallinitialisierung to refer to a waterfall screen for erstel.System integration - If you have time pressure limited in-house technical resources or other project challenges members of the NI Alliance Program can help. Figure -14. Frequency response with 4 996 samples Increasing the frequency resolution results in a more accurate measurement of the damping of the filter around its notch rate.VI Sound and Vibration Toolkit and Sweep Sine Configuration you can specify many configuration parameters to fine-tune sensory sensory parameters to erzielen. Equal Loudness Curves Uses LabVIEW Sound and Vibration Toolkit 5-2 ni.com Chapter 5 Weighting Filter Loudness is a subjective indicator for what is perceived as noise level as expressed in the Phonen. In a two-channel measurement configuration of the excitation signal coupled to the stimulation channel input channel and the input channel coupled to the output of said DUT is the response channel. Figures 6-6 show the results of the continuous detection and integration of the same 38-Hz sinusoidal wave which was used in the example of single shot recording and integration. It also includes power spectra frequency response ANSI and IEC Fractional Analysis and configuration based Express VI for the distortion measurement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
November 2018
Categories |